Magnetic Mold Clamping for Plastic Injection Mold Machines			View Catalog Page
Return to product index.	Request catalog for complete technical data.	Review next product.

Magnetic Mold Clamping for plastic injection mold machines. The new M-TECS 130 (max 266°F) is designed especially for use on plastic injection mold machines. Our new long pole technology uses double magnets to provide up to 20% more clamping force over square pole technology. The flexible design offers quick change of different size molds in a single-minute exchange time.

Advantages:

• Mold changes in a single-minute exchange time.
• 20% more clamping than older magnetic technologies.
• Electrical power only required for two seconds to unclamp, along with numerous other safety features.
• Reduced energy cost.

More on Magnetic Clamps for Plastic Injection Molding

Wedge Clamps, Double-Acting for Injection Molding (For Straight-Edge Tools)
Return to product index.	Request catalog for complete technical data.	Review next product.

Double-Acting Wedge Clamps provide sure, safe clamping of tools with standard straight clamping edges. Their two-piece wedge clamping bolt and block cylinder combine to offer mechanical locking with hydraulic assist. The fully retracted bolt extends from the housing then clamps straight down on the flat surface of the tool without creating any side load. The hydraulically operated clamp then wedges internally, mechanically locking the clamp. Three sizes, with clamping forces from 5,625 to 22,500 lbs. (These compact clamps are the most popular type used in injection molding machines.)

Advantages:

• Flat clamping edge, no special machining required.
• Compact, self-locking design.
• Integrated position monitoring system.
• Retracting clamping bolt ensures clearance for die and mold changes.

Magazine Article: Quick Mold Change For The Plastics Industry

More on Wedge Clamps for Plastic Injection Molding

Magnetic Mold Clamping for Rubber Compression and Injection Mold Machines			View Catalog Page
Return to product index.	Request catalog for complete technical data.	Review next product.

Magnetic Mold Clamping for rubber compression and injection mold machines. The new M-TECS 210 (max 410°F) is designed for the high temperatures of rubber mold machines. Achieve high quality production and mold changes in a single-minute exchange time.

Advantages:

• Increased flexibility – no modification of molds is necessary.
• Change molds in a single-minute exchange time.
• It is not necessary to touch the mold during installation.
• Numerous safety features.
• Permanent magnets mean clamp capacity is not affected by any power loss. Electrical power is only necessary for two seconds to unclamp the mold.

More on Magnetic Clamps for Rubber Molds